Please contact :-
Gentle Automatic Solution Sdn Bhd
Tel: +603-8023 7743 / 8743
Email enquary :-
firstname.lastname@example.org / email@example.com
For more Pneumatic Tools components, please visit https://www.gentle.com.my
Series EX600 Updated May-15
- New Unit type added: SI Unit (EtherNet/IPTM) [New]
- IP67 (Some products are IP40)
- Reduction in wiring time with SPEEDCON (Phoenix Contact).
Just insert and make 1/2 rotation!
- Self Diagnosis Function
- Max. 9 Units, Can be connected in any order
These units are capable of connection using a D-sub connector. There are three types of units, for digital input, output, and input/output. The Digital Output Unit can be connected with an SMC manifold solenoid valve F kit (D-sub connector).
These terminal block units are compatible with individual wiring configurations. There are three types of units, for digital input, output, and input/output. Wiring connection to a sensor connector box, etc., can be carried out easily using only a flat head screwdriver.
This Unit is for inputting a digital signal (ON/OFF signal). The signal of a 2-wire/3-wire auto switch attached to the actuator can be acquired to feedback a signal to the PLC. The control signal of an entire system can be managed by Fieldbus System.
These units input or output analog (voltage/current) signals. A single unit performs both input and output, allowing feedback control wher analog signals are received from a pressure sensor and sent to a pressure controller. Installation space is minimized as well.
A unique clamping method is adopted to prevent screws from falling out.
It is easy to separate the unit just by loosening bracket screws.
The following functions are available for the dual port EtherNet/IPTM product (EX600-SEN3/4).
・Added Compatible Topologies (connection configuration).
・QuickConnectTM Function Available
In the case of a tool changer, it takes about 10 seconds for the communication to be connected in common EtherNet/IPTMproducts, after the power of the device installed on the tool is turned ON. Since the QuickConnectTM function* is available in the EX600-SEN3/4, the communication can be connected in about 0.5 seconds.
・Built-in Web Server Function
The EX600-SEN3/4 has a built-in web server function, which enables status checks, parameter settings and forced output of the EX600 using general-purpose web browsers, such as Internet Explorer. Start-up of the system and maintenance can be performed efficiently.